Car Parts and Accessories


Caring for Tires Auto maintenance part 3

Posted in Bumper, Transmission, Tyres, Wheels by dodo on the June 29th, 2008

Step 7-10. Changing a tire.

Pull off the road well away from traffic and park the car on level ground. Turn on the hazard lights and put the transmission in PARK, or in REVERSE for manual transmissions. Set the parking brake and turn off the engine. Check your owner’s manual for details pertaining to your car. Remove the spare tire and jack.

Step 7-11. Blocking the tires.

Block the wheels at the end opposite of the flat tire to keep the car from rolling.

Step 7-12. Loosening the lug nuts.

Pry off the wheel cover and use the lug wrench to loosen each lug nut about one turn. Some lug nuts are marked with an “L.” Turn these nuts clockwise to loosen. Unmarked nuts are loosened by turning counterclockwise.Car Parts and Accessories

Step 7-13. Jacking the car.

Depending on the car, you either jack it from the bumper or from the side near the wheel. Check the instructions in your owner’s manual. If the ground is soft, place a board under the base of the jack for extra support. Operate the jack slowly and smoothly. Raise the car so that the flat tire is at least 2 or 3 inches off the ground.

Step 7-14. Removing the flat tire.

Remove the lug nuts and place them in the wheel cover for safe keeping. Then remove the flat tire.

Step 7-15. Mounting the spare tire.

Supporting the spare tire with your knee, lift it into position. Align the holes in the wheel with the mounting studs and push the tire into place.

Step 7-16. Installing the lug nuts.

Install the lug nuts with the tapered end pointing in. Tighten all of the nuts by hand; then tighten each one in a crisscross pattern with the lug wrench until they are snug. Lower the car until the tire firmly touches the ground.

Step 7-17. Completing the job.

Finish tightening the nuts as tight as you can in the same crisscross pattern. Lower the car the rest of the way. Tap the wheel cover in place with a rubber mallet or put it in the trunk to install later. Remove the wheel blocks. Put the flat tire and jack in the trunk and have the flat repaired or replaced as soon as possible.

Possibly related posts: (automatically generated)
Caring for Tires Auto maintenance part 3

5 Responses to 'Caring for Tires Auto maintenance part 3'

Subscribe to comments with RSS or TrackBack to 'Caring for Tires Auto maintenance part 3'.

  1. Parts Int said,

    on July 8th, 2008 at 3:32 pm

    Intervals are built around an oil change every 3, 000 miles, an accepted recommendation for most of motorists who are severe service drivers. … Parts Int


  2. on July 9th, 2008 at 4:49 am

    We have all the parts for any car brand including foreign brands, such as the Japanese brand of cars named Daihatsu. … Truck Accessories


  3. on July 9th, 2008 at 1:05 pm

    Our online catalog is safe and easy to use and we offer free shipping on any orders that exceed $50.00. … Replacement Bumper

  4. Car Seats said,

    on July 9th, 2008 at 3:50 pm

    Boot with zipper makes a warm and cozy bed Retractable car seat anchors instantly attach matching Peg Perego car seat (sold separately) point Ê being of the child… … Car Seats

  5. Wheel Parts said,

    on July 9th, 2008 at 5:45 pm

    The suspension system¯ basic functions are to keep the car¯ wheels in firm contact with the road and to provide comfort to its passengers. … Wheel Parts

Leave a Reply


LogoAlexa CounterFeedBurner Counter